I hope everyone had a good start to 2018! I made a few new casts. I also made a new mould, but found that the release agent hadn’t reached into the narrow tip. This meant that when I removed the first cast, little bits of mould came off! This is the first time this has happened to me, but it’s taught me a valuable lesson on master design. Or maybe just spray in more release agent? Anyhow, I don’t think I can really use this mould again – meh.
The other casts came out nicely though! Especially the red squash :).
First (and possibly only) cast of the new mould:
Advertisements
